Configuring your machine for a wireless network
16
3
Connection when another device (C), such as a computer is used as a Registrar.
Routers or access points that support WPS (Wi-Fi Protected Setup) have a symbol as shown below.
(For MFC-J2510/J4510DW) 3
a Press .
b Press Wi-Fi.
c Press WPS w/PIN Code.
d When Switch Network interface to wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
e The LCD will show an 8 digit PIN and the machine begins searching for a WLAN access point/router for
up to 5 minutes.
f Using a computer that is on the network, type “http://access point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
1
.) Go to
the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in e to the
Registrar and follow the on-screen instructions.
1
The Registrar is normally the WLAN access point/router.
The setting page may be different, depending on the brand of WLAN access point/router. See the
instruction manual that came with your WLAN access point/router.
To Next Page
Loading...
