4. Using a computer connected to the network, type in your browser's address bar the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
5. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows Vista
®
, Windows
®
7, Windows
®
8, or Windows
®
10 computer as a Registrar,
complete the following steps:
6. Do one of the following:
• Windows Vista
®
Click (Start) > Network > Add a wireless device.
• Windows
®
7
Click
(Start) > Devices and Printers > Add a device.
• Windows
®
8
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
• Windows
®
10
Click
> All apps > Windows System > Control Panel. In the Hardware and Sound group, click
Add a device.
• To use a Windows Vista
®
, Windows
®
7, Windows
®
8, or Windows
®
10 computer as a Registrar, you
must register it to your network in advance. For more information, see the instructions supplied with
your wireless LAN access point/router.
• If you use Windows
®
7, Windows
®
8, or Windows
®
10 as a Registrar, you can install the printer driver
after the wireless configuration by following the on-screen instructions. To install the full driver and
software package, use the Brother installation disc.
7. Select your machine and click Next.
8. Type the PIN displayed on the machine's LCD, and then click Next.
9. Select your network, and then click Next.
10. Click Close.
MFC-J2730DW/MFC-J5730DW/MFC-J5930DW
1. Press [Settings] > [Wi-Fi] > [WPS w/ PIN Code].
2. When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
4. Using a computer connected to the network, type in your browser's address bar the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
5. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows Vista
®
, Windows
®
7, Windows
®
8, or Windows
®
10 computer as a Registrar,
complete the following steps:
6. Do one of the following:
404
To Next Page
Loading...
Need help?
General
Weight and Dimensions
