USING TEMPLATES
This function allows you to create two types of
cable labels.
Example: Cable Label 1
NOTE
• You cannot set label length when printing Cable
Labels.
• To clear all text and settings or text only, press
/ [Text&Format]/[Text Only]
.
• You can set the Font, Size, Style and Frame
while entering texts.
• To exit templates and return to the text input
screen, do one of following:
a) Press .
b) Press
/ to select [Exit], and then press
when "Print" appears.
• To preview labels, press the Preview key when
[Print] is displayed on the LCD.
• You cannot save labels created using templates
to memory.
This function allows you to create various labels
using the built-in templates. See the Text Label
templates table included in this insertion sheet.
XExample:
[Template that includes one
repeated graphic]
NOTE
• Press the Space key to return to the initial
setting for "Label Length" mode. The initial
setting is [Auto].
• To clear the text, move the cursor to the right side
where you wish to clear, and then press .
• To clear all text, press , then “All Clear”
appears. Press to clear. Press to cancel.
• You cannot set the Font, Size, Style and Frame
while entering texts.
• If you set the longer label length than the default
([Auto]), the text label is printed repeatedly
within the set length. The text label may not be
fully printed depending on the set length.
• The available label length setting changes
depending on the number of texts you entered.
• These templates are available when using 0.47"
(12mm) wide tape cassettes.
• You cannot edit the templates.
To Next Page
Loading...
Need help?
General
