NOTE
• When you set [Chain Print], feed the tape before
using the cutter otherwise a part of the text may
be cut off.
• When you set [Half] or [Narrow], displayed label
length is the length from the printed dots ( ) to
the end of the label. Cut along the printed dots
(:) with scissors.
• To print more than one copy of a label with
minimum margin, set the margin to [Narrow].
• Do not pull the tape since this may damage the
tape cassette.
• After pressing , "Accepted" is displayed for
approximately one second.
You can save up to 15 labels and recall them for
printing at a later date. A maximum of 80
characters can be saved per file, a maximum of
1200 characters can be saved in total memory.
You can also edit and overwrite the stored labels.
X Save
X Print
X Open
NOTE
• You can also enter the File menu by pressing
.
• If you try to store a label when there is already a
label stored to that number, a message
“Overwrite OK?” appears. Press to save
your new label. Press to cancel.
• You must type text before starting the save
function.
• After pressing , "Accepted" is displayed for
approximately one second.
Printing Labels (continued)
LCD Label image
Full
Half
Narrow
2.7"
ABC
1.6"
ABC
1.0"
ABC
Saving Label Files
Enter Text / [File]
/ [Save] /
/ [File]
/ [Print] /
[Copies: ]
// -
/ [File]
/ [Open]
/
To Next Page
Loading...
Need help?
General
