Brother PT-E550W - Settings Tabs; Import

Communication Settings (Windows only)
24
7
IMPORTANT
• If the [Disable these settings] check box is selected, the settings in that tab are not saved.
• The following information is not saved with the settings commands.
• Node name.
• IP address, subnet mask and default gateway (when the IP address is set to [STATIC]).
• The saved communication settings commands are only intended to be used for applying settings to a
printer. The settings cannot be applied by importing this command file.
• Saved command files contain authentication keys and passwords.
Take necessary measures to protect saved command files, such as by saving them in a location that
cannot be accessed by other users.
• Do not send the command file to a printer whose model was not specified when the command file was
exported.
 Import
• Import from the current computer wireless settings.
Imports the settings from the computer.
NOTE
• Only personal security authentication settings (open system, public key authentication and
WPA/WPA2-PSK) can be imported. Enterprise security authentication (such as LEAP and EAP-FAST)
and WPA2-PSK (TKIP), WPA-PSK (AES) settings cannot be imported.
• If multiple wireless LANs are enabled for the computer being used, the first wireless settings (only personal
settings) that are detected will be considered for importing.
• Only settings (communication mode, SSID, authentication method, encryption mode and authentication
key) from the [Wireless LAN] tab - [Wireless Settings] pane can be imported.
• Select a Profile to import.
Imports the exported file and applies the settings to a printer.
Click [Browse] to display a dialog box the file. Select the file to be imported. The settings in the selected
file appear in the settings display/change area.
NOTE
• All settings, such as wireless settings or TCP/IP settings, can be imported. However, node names cannot
be imported.
• Only profiles that are compatible with the selected printer can be imported.
• If the imported profile’s IP address is set to [STATIC], change the IP address of the imported profile, if
necessary, so that it does not duplicate the IP address of an existing printer on the network whose settings
have been completed.