67
OUTBOARD RIGGING
EVINRUDE E-TEC MODELS 40–90 HP
3
SystemCheck Harness
Connections
Place th e wirin g harne ss through notch in lower
motor cover a nd ro ute t o the recess in th e fly-
wheel cover. Secure the cable with a tie strap as
shown:
Before installing electrical connectors, check t hat
the seal is in place. Cl ean off any dirt from con-
nectors. Apply a light coat of Electrical Grease to
the seal only. DO NOT fill connectors with Electri-
cal Grease.
Arrange connectors in flywheel cover.
Install electrical cover and secure with screws.
BE SURE all harnesses and wires
are not pinched, cannot contact flywheel, and
do not interfere with moving throttle or shift
linkages.
1. Recess
2. Tie strap
002011
1. Seal 42079A
001999
002102
To Next Page
Loading...
