VIBROCONTROL 920 Display and operating elements
__________________________________________________________________________________
Limit value LIM 2
Red LED / LIM 2 Relay
If the current measurement value is higher than the limit value and remains
at this level for longer than the set time delay, the LED will light up. The LIM 2
relay will react according to the defined setup. It will be energized when set
up as normally de-energized and will be de-energized when set up as a
normally energized relay.
If an OK error occurs during a LIM2 activation, the limit signal (LED and
relay) will be reset to the normal status for the duration of the OK error.
3.5 Reset
Normal operation
Reset the event signal as well as the associated relay.
The "REL.RESET" terminals have no function in connection with an OK
error.
Parameter mode
Leave the parameter setup mode. Changes to the parameter values are not
activated.
3.6 Store
Push Mode and Reset simultaneously:
Leave the parameter setup mode. Changes to the parameter values are
activated.
To Next Page
Loading...
Need help?
General
