5 Setups
General
The parameters are divided into three Groups each with respectively seven
parameters. The parameters in Groups 1 and 2 are concerned with
configuration parameters while those in Group 3 are concerned with service
parameters.
Viewing or making changes to parameter values can only be done after first
entering a code number associated with the Group. Parameter entries only
take effect and are stored after leaving the entry mode, i.e. after
simultaneously pushing the MODE + RESET buttons. Changes to the
parameters are ignored when the entry mode is exited by pushing the
RESET button.
5.1 Function: Displaying parameters
MODE button
Push once. The number 1 is displayed in the mode display field.
resp. buttons
Push repeatedly until the desired code number is displayed in the
measurement value field.
MODE button
The mode selection is accepted. Now the parameter number 2 is displayed
and the associated parameter value is displayed in the measurement value
field.
MODE button
Pushing the MODE button switches to the next parameter.
RESET button
Pushing the RESET button exits the display mode. The corresponding value
of the input signal is displayed in the measu-rement value field.
To Next Page
Loading...
Need help?
General
