BRUEL & KJAER VIBROCONTROL 920 - 10 Parameter List

Parameter list VIBROCONTROL 920
VC920E / C102833.002 / V 13
Page 31 / 33
10 Parameter list
Instrument number .............................................................................
Measurement point .............................................................................
.............................................................................
.............................................................................
Parameter Group 1
Mode 2 Range assignment for analog output ....................................................... mm/s
Mode 3 Limit value LIM 1 ....................................................... mm/s
Mode 4 Limit value LIM 2 ....................................................... mm/s
Mode 5 Time delay LIM 1 ....................................................... s
Mode 6 Time delay LIM 2 ....................................................... s
Mode 7 High-pass filter value ....................................................... Hz
Parameter Group 2
Mode 2 Sensor sensitivity .......................................................
Mode 3 Correction factor .......................................................
Mode 4 DC Current output range ....................................................... mA
Mode 5 Limit relay operating mode .......................................................
Mode 6 LED display .......................................................
Mode 7 Analog outputs .......................................................
Parameter Group 3
Mode 2 Sensor power ....................................................... V
Mode 3 Internal voltage 5 Volt ....................................................... V
Mode 4 Internal voltage 17 Volt ....................................................... V
Mode 5 Housing internal temperature ....................................................... °C
Mode 6 Input amplifier factor .......................................................
*
Mode 7 Output of D/A converter .......................................................
*
∗ The value is dependent on the actual input signal.