5.2 Function: Changing parameter values
MODE button
Push once. The number 1 is displayed in the mode display field.
resp buttons
Push repeatedly until the code number associated with the corresponding
parameter Group is displayed.
Parameter Group Code Number
1 11
2 22
3 3
MODE button
The mode selection is accepted. Now the parameter number 2 is displayed
and the associated parameter value is displayed in the measurement value
field.
resp buttons
Switching the parameter values to next higher resp. next lower value.
MODE button
By pushing the MODE button you can switch to the next parameter. If
changes are made to the parameter values, these are saved in an
intermediate memory until you exit the parameter mode.
MODE + RESET buttons
All parameter settings are accepted and take immediate effect. The
parameter mode is exited; the corresponding value of the input signal is
displayed in the measurement value field.
RESET button
Changes made to the parameter settings are ignored. The previous
parameter values are retained. The parameter mode is exited; the value
corresponding to the input signal is displayed in the measurement value field.
To Next Page
Loading...
Need help?
General
