Bruker Daltonik GmbH ultraflex III Mass Spectrometer
1.2 Site Preparation Specification
Before starting the installation of the instrument the site must be properly prepared.
Please refer to the Site Preparation Specification document that is sent to any
customer prior to the shipment of the instrument.
It contains information regarding the device requirements, such as operating
environment, gas supply, power, exhaust, venting, grounding, etc.
This document has to be verified and returned with your signature to Bruker before a
service representative will start the installation.
1.3 Safety
Safety considerations for the ultraflex III spectrometer include:
ultraflex III Safety Symbols (chapter 1.3.1) •
•
•
•
Manual Conventions and Symbols (chapter 1.3.2)
Operating Precautions (chapter 1.3.3)
Electrical Safety (chapter 1.3.4)
1.3.1 Safety Symbols
The following symbols may be found on or near various components of the mass
spectrometer:
Table 1-1 Safety Symbols
Symbol Description
Indicates that an operation or condition on
the instrument could cause instrument
damage if precautions are not followed.
This can be any type of hazard. When this
symbol is observed, refer to the safety
pages in the manual for further
information.
Indicates the danger of electric shock due
to the presence of high voltage, if
precautions are not followed.
ultraflex III User Manual, Version 1.0 10
To Next Page
Loading...
