Bruker Daltonik GmbH Instrument Layout
a) Permanent lit: Warm-up phase of the laser device (Class IV Laser Product) in
progress or the system is not ready for measurement, e.g., the docking
procedure in still in progress, HV is off, etc. It takes some time, even when all
parameters comply with the requirements. This state is reflected
simultaneously on the PC screen providing details via flex Control™.
b) Flash: A subordinated malfunction has occurred, which must be verified by the
user (less N2 pressure, interlock open).
8. Error:
a) Permanent lit: malfunction, requires intervention of the user or a service
technician; the tool tips feature on the PC shows details (flexControl™).
b) Flashing: (combined with Target Error): Service mode or firmware update.
9. Mains: Permanent lit, when the main circuit breaker is on.
Power On / OFF: OFF vents the instrument.
3.1.2 Rear Panel
At the rear of the instrument (Figure 3-3), there are the following connections:
CID:
• Collision gas inlet for argon or helium (6 bar maximum) for optional Collision
Induced Dissociation and flushing the collision cell.
• Switch to flush the CID-cell (after changing the collision gas).
• Flushing gas outlet.
Gas supply:
• Compressed air connection to operate the slide valve. Alternatively this port
might be externally connected with the nitrogen inlet for the laser to a common
N
2
supply.
• Nitrogen inlet to operate a N
2
-laser (Class IV Laser Product).
• Gas inlet to vent the instrument.
ultraflex III User Manual, Version 1.0 21
To Next Page
Loading...
Need help?
General
