Bruker Daltonik GmbH
Safety Instructions
The following symbols may be found on or near various components.
Before starting the installation, pay attention to these important safety instructions!
Warning
Warning attracts attention to procedures that could result in personal injury, if protocols
are not followed.
This symbol is placed on the product in the area where a hazardous voltage is present.
Only trained service personnel should perform work in this area.
When the instrument is operating high DC voltages are present, in addition to the 230V
AC mains supply. All panels must be fitted prior to operation. Only under these
circumstances does the instrument comply with the electromagnetic radiation
guidelines (EC certificate).
Laser radiation
Indicates that laser light may be present.
The autoflex with the closed safety cover is a Class I Laser product.
With safety cover opened it turns to a Class IV Laser product.
Caution
Caution attracts attention to procedures that could result in damage to
the instrument, if protocols are not followed.
ultraflex III User Manual, Version 1.0 vii
To Next Page
Loading...
