Bruker ultraflex Series - Closing and Switching On the Instrument; Checking High Voltage Connections

Bruker Daltonik GmbH 5 Closing and Switching On the Instrument
5 Closing and Switching On the Instrument
5.1 Check HV Connections
Before closing the source, check that the Lens- , P2- and P1-shield- cables are still in place
(see Figure 5-1, Figure 5-2, and Figure 5-3).
Figure 5-1 Connection to the Lens
plate
Figure 5-2 Connection to the P2 plate
Figure 5-3 Connection to the P1 shield (Prim plate)
ultraflex Series Cleaning Manual Revision 2 Page 39 of 44