— 6 —
The following safety instructions are provided to alert you to precautions which, if not
followed, may cause serious injury to yourself or others. Please read these instructions com-
pletely. Cross-Tech Manufacturing can not cover every incident that might be a hazard.
Extreme caution should be used at all times. Only use Brush Wolf Brush Cutters for the pur-
pose for which it has been designed. Always operate a skid steer with a forestry rated door
and cab. Safety goggles and hearing protection must be worn at all times.
Site Inspection: Before operation of your Brush Wolf, carefully inspect the area to be
cleared. Remove any items which may be picked up and thrown by the cutting blades; wire,
pipes, or rocks. Mark any object too large to move. This is an important step to help avoid
damage to property, the Brush Wolf brush cutter, your skid steer or personal injury. If an
object is struck when operating the Brush Wolf, immediately shut down power to both the
attachment and the skid steer. Any damage should be corrected and tested before continu-
ation of cutting.
Equipment Inspection: Prior to inspection, disconnect the unit from the skid steer. To
inspect or to make repairs under the Brush Wolf cutter deck always block the unit securely
in order to prevent accidental release of the lift mechanism. Inspect all hydraulic hoses and
shields to ensure they are in good condition and without holes before pressurizing. Hydrau-
lic fluid can escape under pressure and may cause serious injury or death. Wear safety gog-
gles, ear protection, hard hat, and only operate the skid steer behind shatter proof forestry
rated door and cab.
Skid Steer Auxiliary Hydraulic Flow: Check the specifications of the Brush Wolf models
rated GPM to correctly match the hydraulic flow of your skid steer to ensure proper opera-
tion.
Do Not operate near bystanders, vehicles, pets, livestock or buildings. Objects may dis-
charge while cutting with the Brush Wolf and has the potential to cause serious injury.
Do Not place hands, feet or other objects under the deck while the Brush Wolf is in oper-
ation. To inspect or perform maintenance under the deck, always shut down the power to
the Brush Wolf, shut-off the skid steer engine, disconnect hydraulic hoses, and block the
unit securely.
Do Not raise the mower deck when blades are rotating. Operation with the mower raised
will expose the cutting blades and the potential for injury or death.
Do Not allow children to operate a rotary brush cutter. Only individuals with skid steer
experience who are well acquainted with the rules of safe operation should be allowed to
operate the Brush Wolf.
Safety Instructions
To Next Page
Loading...