properDC/AC µA or DC/AC mA position.
② Break the current path to be tested. Connect the red test
lead to the more positive side of the break and the black
test lead to the more negative side of the break.
③ Turn on power to the circuit. The measured value show on
5-6. DC/AC 10A measurement
① Insert the red test lead into the input terminal marked as
② The measuring procedure is same as that of 5-5 section..
●
For safety’s sake, the measuring time for high current should be
≤10 second for each measurement and the interval time between
two measurement should be greater than 5 minutes.
●
When current measurement has been completed, disconnect the
connection between the testing lead and the circuit under test.
5-7. Temperature measurement [ Only for ADM02]
To measuring temperature shuld be use the K-type probe :P3400.
① Set the rotary switch to the “TEMP” range. In this time, The
environment temperature value displayed on the LCD.
② Insert the K-type probe to the two “COM” and “TEMP”
terminals. The two “+” and “-“ pins of temperature probe(P3400)
must be direct at the “COM” & “
℃
”terminal respectively.
③ The measured temperature value will be displayed on the LCD.
6-1. Replacing the battery
When meter display the battery must be replace to
maintain normal operation.
① Disconnect and remove all test probes from any live source
② Open the battery cover on the bottom case by screwdriver.
To Next Page
Loading...
