If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
20
Switching the handset on and o
1. Press and hold
Making an external call
1. Press
.
2. When you hear the dial tone, type the number.
When the call begins, the light on the phone’s base
Preparatory dialling
mistakes before the call is connected. If you make
a mistake, press
to delete the last digit.
2. Press
to dial.
Ending a call
Press
.
Receiving a call
When you get a call, your phone will ring and the
caller display service, the caller’s number will show
on the display. Press
to answer the call.
Using the phone
on again, the phone will need
to be charged for some time,
before the true charge status
can be recalculated by the
phone and accurately displayed.
Call timer
Your handset will automatically
time your outgoing and
incoming calls. The handset
shows the length of time both
during and for a few seconds
after your call.
When you make a call,
the In use light on the base
comes on.
Auto Hang-up
If auto hangup is set to On you
can end a call by placing the
handset back in the base.
you’ll need to press
to end
the call.
Auto hang-up On is the default
setting. See page 51.