If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
Help 57
• Do Not Disturb may be switched on. See page 22.
• Make sure the handset is registered to the base. See page 52.
No display
• Recharge or replace the batteries.
Range icon ashes
• Make sure the handset is registered to the base. See page 52.
• Check that the mains power is correctly connected to the base.
• Check that the handset is within range of the base.
• If the batteries are low, place the handset on the base/charger to recharge.
You hear the busy tone when you press
• Make sure the handset is in range of the base.
• Another handset registered to your BT3560 base may be on the line.
No caller display number or name is displayed
• Have you subscribed to a caller display service from your network provider?
See page 32.
• The caller may have withheld their number.
• The network might not have the caller’s number information.
• There isn’t an exact name or number match in your phonebook. Check that you’ve
stored the full STD dialling code.
To Next Page
Loading...
