Electrical systems – 5000 LPE 240
Error codes
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 10- 17
Code C42
Description Warning of high battery voltage
Possible error
cause
Battery voltage > 33 volt.
Energy return feed to battery during motor braking
with a fully-charged battery.
Action 1. The fault disappears after a few lifts, once the
battery has been run down slightly.
2. Check the cabling, the battery contact and the
contact points on main contactor K10.
Code C43
Description The travel regulator shuts off due to excess or
subnormal temperature.
Possible error
cause
Too intensive operation or ambient temperature
too cold.
Error in the travel regulator.
Temperature levels below -25
o
C or above +85
o
C
reduce running speed.
Action 1. Check that the M12 fan is functioning.
(Applies to P 24)
2. Check that the travel regulator is installed with
good contact with the chassis.
To Next Page
Loading...
