Preventive maintenance – P2 LWE 180/200 LPE 200
Maintenance schedule
Order number Date Valid from serial number T-code
225553-040 2005-05-11 723984- 660, 661, 662, 497
© BT Europe AB Service Guide LWE180, LWE200, LPE200, LPE240 4- 3
5110 Battery
5110.1 Check the electrolyte level, 10-15 mm over
the cell plates
M
5110.2 Check connections to battery,
truck and charger
I
5110.3 Check that the cell and pole guards are
undamaged
I
5110.4 Check the fluid density and temperature M
5110.5
Remove overflow fluid from the battery trough
C
5110.6 Check the battery locking I I
5400 Power system
5400.1
Cleaning and checking of mounting in chassis
C/T
1
C/T
5400.2 Re-tighten cable connections
T
1
5400.3 Check the contactor points on K10 and K30 I
5400.4 Check the movement of the contactors I
5400.5 Check the cable insulation I
5700 Electronic circuit board
5700.1 Check connectors and cables T1 I
5700.2 Check all segments on the display I
6100 Hydraulic system
6100.1 Check hoses and connections for wear I
6100.2 Check hoses for wear and damage I
6100.3 Check the oil tank for cracks, leakage and
damaged mountings
I
6100.4 Check that the oil level is correct I
6100.5 Change the oil and clean the filter
L
5
L
6600. Lift cylinder
6600.1 Check for leakage I
6600.2 Check the mountings I
I: Inspect, rectify and change if necessary. T: Tighten. C: Clean. L: Lubricate.
M: Control measurement, rectify if necessary
Pos.
No.
Work to carry out
Interval in hours 5 20 80 500 1000 3000
Interval in days/weeks/months 1d 1w 1m 6m 12m 36m
To Next Page
Loading...
