Lights What’s happening What to do
No light The power is o or
you’ve turned the
lights o
If you haven’t turned the lights o, check that the Hub’s Power button is on, its power cable
is plugged in correctly at the mains and power is turned on. If there’s still no light, call us on
0800 111 4567. We’re usually less busy between 12pm and 6.30pm
Green light The Hub is starting up Wait a couple of minutes for it to start
Flashing
orange light
The Hub is connecting
to broadband
Give it a minute or two to connect. The light will turn steady blue when your Hub is ready
Flashing
purple light
The Hub is working but
the broadband cable
isn’t connected
Check the broadband cable (black with grey ends) is plugged in correctly and you’re using a lter,
if needed. You can see which cable goes where on page 4
Steady
orange light
The Hub is working but
isn’t connected to the
internet
Connect a device to your Hub using a cable or wi-. Open a new web browser window and follow
the on-screen help wizard to get connected
Red light There’s a problem
somewhere
Using the Power button, turn your Hub o and on again. If the light still doesn’t turn blue, use a paper clip to
press your Hub’s Factory Reset button. If this doesn’t x it, call us on 0800 111 4567. We’re usually less
busy between 12pm and 6.30pm. Make sure you’re next to your Hub with a computer or device if you call
Blue light The Hub is working ne If you can’t get online, there might be a problem with your computer, tablet or mobile device.
Turn it o and then on and try again. If you’ve still got a problem, get some help from the
manufacturer or supplier
WPS button
and light
If it’s ashing blue, it’s waiting for you to press the WPS button on your computer or device (you’ve got
two minutes). If it’s ashing red, it didn’t connect – give it a couple of minutes and try again.
No light means that it’s connected successfully
What your Hub lights mean
WPS Wi-Fi Setup
To Next Page
Loading...
