Controls and instruments truck with 360° steering
© BT 237077-040
24
Steering wheel (1)
• When small steering wheel adjustments are required and
when driving at high speed, steer the truck with the finger-tips
on the steering wheel hub (1). For low speed driving and turn
-
ing the truck, rotate the wheel faster with the help of the steer-
ing wheel spinner (2).
The driving wheel does not incorporate a limit position, this
makes it possible to steer around 360°.
WARNING!
Lost stability.
The truck can overturn and loads can fall off when rotating the
steering wheel fast at high speed. Steer only with the finger
tips on the steering wheel hub when driving at high speed.
NOTE!
Overloading the mounting.
Do not use the steering wheel as a handle when entering the
truck. Instead, use the rail on the motor casing.
WARNING!
Loose wheel console.
You can lose control of the truck if the wheel console is loose.
Tighten the lock handle following adjustment.
Hydraulic controls (2)
There is a maximum of one joystick and two buttons on the con-
trol panel with which you can control all the hydraulic functions.
The movement of the lever is processed by the logic card, which
then sets the correct oil flow through the proportional valve.
Speed changes on the function are obtained by moving the lever
forwards or backwards more or less.
Press the buttons to activate the function.
NOTE! When the key is in the 0 position none of the hydraulic
functions can be used.
Function
Lever A
+ Lift forks
- Lower forks
Button B
+ Project stabiliser (optional)
Button C
+ Retract stabiliser (optional)
12
C
A
B
To Next Page
Loading...