BT SSE160L - Driving Operation; Driving with 360° Steering

Driving truck with 360° steering
© BT 237077-040
52
Driving truck with 360°
steering
Starting the truck
• Make sure the emergency switch off is not pressed in.
• Turn the ignition key to position l. The instrument lighting
should come on.
• Make sure the battery controller indicates a sufficient charge
level (1/2 - 1).
NOTE!
Low charge level.
A low charge level can result in damage to the battery with pro-
longed operating.
Do not drive without first charging the battery.
• Place the left foot on the safety pedal.
NOTE!
Risk of crushing.
Risk of crushing exists if any part of the body is outside of the
operator’s cab.
Always ensure that the whole of your body is inside the protec-
tive cab.
• Select the travel direction.
WARNING!
Function failure.
Safety can be jeopardised.
Always check the following safety functions before starting the
day’s work.
- That the horn and emergency switch off function correctly.
- That the steering functions correctly.
- That the brakes function correctly.
- That the hydraulic functions are operational.
• Start gently by accelerating slowly until you reach the desired
speed.
WARNING!
Dangerous driving.
Accidents can occur.
Always drive with care, good judgement and responsibility as
set out in the general safety regulations.