BT SSE160L - Regular Maintenance and Cleaning

Maintenance
© BT 237077-040
68
Maintenance
Ensure the truck is given a regular maintenance service after
250 driving hours. The truck´s safety, efficiency and service life
is dependent on the service and maintenance it is given.
Only use BT approved spare parts when service and repair work
are carried out.
BT recommends that you contact your closest BT representative
to sign a service and maintenance agreement to ensure the
truck’s operating economy and safety.
Safety regulations with maintenance
work
Only personnel that have been trained in the service and repair
of this type of truck are authorised to carry out service and repair
work.
• Do not carry out any maintenance work on the truck unless
you have the correct training and knowledge to do so.
• Keep the area where you carry out the service clean. Oil or
water makes the floor slippery.
• Never wear loose objects or jewellery when working on the
truck.
WARNING!
Short-circuiting/Burns.
When working with the truck’s electrical system, short-
circuiting/burns can occur if a metal object comes into contact
with live electrical connections.
Remove watches, rings or other types of metal jewellery.
• Always disconnect the battery by pulling out the emergency
disconnector when carrying out maintenance work on the
truck unless otherwise stated in this publication or the Service
Manual.
• Always switch off the truck’s power supply before opening the
covers on the drive unit or electrical system.
• Relieve the system pressure slowly before starting work on
the truck’s hydraulic system.
• Use paper or a rigid sheet of cardboard when checking for oil
leakage. Never use your hand.