Controls and instruments truck with 360° steering
© BT 237077-040
29
Display and programming
There is the possibility to look at the machine specific register,
but not to reprogram it. However the clock can be programmed,
for example, for summer or winter time.
Display
To display the machine specific register proceed as follows:
• Open the motor casing.
• Switch on the ignition key to feed voltage to the electronics.
• Press switch SELECT, on the electronic card.
• To step through the register one step at a time press SELECT
once.
The programmed parameters will be displayed in the character
window (C).
• Warning codes and Error codes
• Parameters
• Running time
The address register’s ”No” will be shown on the left-hand side
and ”the value” on the right-hand side.
Character window (B) indicates the programmed time of day.
To Next Page
Loading...