Battery
© BT 237077-040
62
Battery
• Check that the battery in the truck is a 24 V traction battery
having a weight within the minimum/maximum values stated
on the identification plate.
Replacing the battery
• Only replace the battery with a battery of the same weight as
the original. The battery weight affects the truck’s stability and
its braking capacity. Information on the lowest permitted bat
-
tery weight can be found on the truck’s identification plate.
WARNING!
Risk of moving the centre of gravity.
A battery weight that is too low gives impaired stability and
braking capacity.
The battery weight must be in accordance with the information
on the truck’s identification plate.
When changing the battery proceed as
follows:
• Press in the emergency switch off.
• Open and drop down the doors to the battery compartment.
• Remove the lock.
• Roll out the dead battery onto the door.
• Disconnect the battery connector from the battery.
• Lift out the discharged/old battery.
• Lift in the new battery.
• Connect the battery connector to the battery
• Roll the new battery into the compartment and mount the
safety catch.
• Close the door to the battery compartment and secure it.
WARNING!
Risk of short-circuiting.
The cables can be damaged and cause a short-circuit.
Ensure the battery cables are not crushed.
• Release the emergency switch off.
• Ensure the ignition key is in the 0 position.
WARNING!
Falling battery.
When changing the battery, it can be dropped.
Always lift the battery using an approved lifting device and use
a battery yoke intended for the battery.
To Next Page
Loading...