Installation and Connections
SM-DIN/MULTILOOP.. - 2.30 -
TS55/TMS sensor and Diaper Feeder device identification in progress.
This message appears when the identification is executed from PC or Matrix Touch
terminal.
Diaper Feeder device identification in progress.
This message appears when the identification is executed from PC or Matrix Touch
terminal.
HTP (Matrix Cube) sensor identification in progress.
This message appears when the identification is executed from PC or Matrix Touch
terminal.
HTP (Matrix Cube 2 or Matrix Cube 3) sensor identification in progress.
This message appears when the identification is executed from PC or Matrix Touch
terminal.
Warning due to speed too high on TMS sensors.
Other warning as, SPD LOW (WARN), TENS HIGH (WARN), TENS LOW (WARN), are
equally identify and classified in the SM-DIN
The position of the involved sensor/device appears alternate to the message/error screen page.
To Next Page
Loading...