btsr SM-DIN/MULTILOOP/ETH - Functions and Firmware Version Details

Installation and Connections
SM-DIN/MULTILOOP.. - 2.31 -
2.7 FUNCTIONS AND FIRMWARE VERSION DETAILS
Item
Firmware
version
Available functions
MTX/TOUCH/DIAPER &
MTX2/TOUCH/DIAPER
Compatible version
0
3.1
First release
Modifications on Communication Protocol (refer to
dedicate documentation)
1
3.3
Generic Optimization and bug fix
2
3.5
Modifications on Communication Protocol (refer to
dedicate documentation)
3
3.6
Alarm/Warnings Optimization
4
3.7
Speed reading and spool change Optimization
Introduction of alarm reset via Ethernet
5
3.8
Generic Optimization
6
4.0
Generic Optimization
Introduction of PC LINK DUOLOOP debug software
communication functions
7
4.2
Remote alarm reset extension
Default Motion Control parameter value set to 0
Introduction of DF DISPLAY function
Introduction of LOCK SETPOINT function
Introduction of data speed reading also with Multiloop
disabled
8
4.4
Introduction of ACTC and MSC compatibility and functions
Modifications on Communication Protocol (refer to
dedicate documentation)
Introduced SPEED HIGH / LOW WARNING notification
1.0.00
9
5.9
Generic Optimization
Introduction of DISABLE DEVICE function
Introduction of BUS HANDSHAKE function
Introduction of DF EDITOR LOCK function
Modifications on Communication Protocol (refer to
dedicate documentation)
Introduction compatibility with MATRIX TOUCH panel for
data collection
1.0.00
10
6.5
Modifications on Communication Protocol (refer to
dedicate documentation)
Motion Control Optimization
Introduction of DF upgrade trough FTP protocol
Alarms/Warning priority Optimization
Generic Optimization and bug fix
1.0.10
11
6.6
Generic Optimization
1.0.10
12
6.7
Introduction of SMDIN and DF firmware upgrade through
MATRIX TOUCH panel USB port.
Graphics optimization of SMDIN display
1.0.10
13
7.4
Introduction of external “SAMPLE” event generated from
external input.
Introduction of external Alarms Reset management
Fix of network parameter setup for PLC communication
1.0.27