btsr SM-DIN/MULTILOOP/ETH - Page 52

Installation and Connections
SM-DIN/MULTILOOP.. - 2.32 -
Introduction of “THREAD-UP” function on MATRIX TOUCH
panel
Introduction of “MOTION” control for TMS sensors
Generic Optimization and bug fix
Modifications on Communication Protocol (refer to
dedicate documentation)
14
7.5
Added new alert of “NO RUN “alarm (specific for Mask
application)
Corrected error of warning/error assignment for some
alarm codes.
Generic Optimization
1.0.32
15
7.8
Introduction of new working logic for Motion Control
Tension Control is moved to TS44/TFS sensors in case of
“SINGLE LOOP” mode
Introduction of ”DF MIN TENSION” parameter on SMDIN
board menu
Modifications on Communication Protocol (refer to
dedicate documentation)
1.0.40
16
7.9
Corrected exclusion debounce error via HW
Added machine speed programming and actual speed
visualization on MATRIX TOUCH panel
Optimization of Alarm/Warning notification
Corrected Motion Control DF and TMS logic, added
separated parameters for DF motion control and TMS
Added new parameter for Tension High Warning
Corrected identifying errors with Smart Matrix terminal
Modified alarms counting mode for local panel
Modifications on Communication Protocol (refer to
dedicate documentation)
1.0.40
17
8.1
Modified the SPEED visualization mode on MATRIX
TOUCH panel
Optimization on motion control
Added possibility of DF firmware revisions reading on
MATRIX TOUCH panel
Corrected triggering of EXTERNAL event function error on
Fieldbus
Added possibility of Speed Setpoint programming from
Fieldbus
Modifications on Communication Protocol (refer to
dedicate documentation)
1.0.46
18
8.2
Optimization of DF upgrade procedure from Matrix Touch
panel and FTP
Corrected Alarm/Warning notification logic
15.4
19
8.4
Alarms / Warnings priority revision on notification and
visualization (Yarn Break, Comm. Err., Spool Change…)
Spool change warning optimization to improve correct
detection
Modification of DF tension average visualization on
MATRIX TOUCH panel graphics
15.5
20
8.5
Removed UNDERFLOW alarm on disabled
positions
Fix of setting for reference speed value to be displayed on
Matrix Touch panel
Trigger reset forced for tension and speed control when
disabled
16.1
21
8.6
Inserted TMS - Line Speed reference speed programming
from PLC (function 0x25)
Added parameter programming functions for Speed
Alarm/Warning without NVM save
16.2