btsr SM-DIN/MULTILOOP/ETH - Page 53

Installation and Connections
SM-DIN/MULTILOOP.. - 2.33 -
IS3F/HTP/SE logic modification to keep track of active
spool side
Sequence reset and descriptor changes on HMS board
22
8.9
Management of PFD parameters from SMDIN, Matrix
Touch Diaper panel and PLC communication protocol
Independent parameters management for gain and others
Firmware version reading of PFD, TS55/TMS (from MTX-
TOUCH) and ETHERNET/PROFINET interface board
(from SMDIN)
Introduced TMS and PFD firmware upgrade from Matrix
Touch Diaper panel and FTP
Modified the SMDIN “WRK PARAMETERS” and MTX-
TOUCH “STYLE” editor for introduce the new
programmable option (PFD)
16.4
23
9.1
Possibility to disconnect TMS without communication error
in case of activation in I/O configuration of Flag “Exclude
DF Off Positions”
16.9
24
9.2
Introduced the possibility to LOG and DECODE the
communication functions from PLC BUS (MTX-TOUCH
“Service > Bus Messages Log”).
Introduced the possibility to set the Unix UTC Time from
PLC.
Modified the SMDIN “WRK PARAMETERS” and MTX-
TOUCH “STYLE” editor for introduce the new
programmable option (DIAPERFEEDER’s Ramps and
TENSION LOW WARNING%)
17.1
25
9.4
Intermediate version
17.1 -17.8 – 17.9
26
9.6
Changed the TS55’s led modality when ACTD optional
device for yarn-hold function it’s connected (elastics
trapper system).
Introduced TS55 firmware upgrade from Matrix Touch
Diaper panel and FTP.
Introduced the warning FBUS OVER generated in case of
unexpected functions received from PLC.
17.9
27
9.7
Fixed bug related to exclusion signal accidentally activated
during identify procedure.
17.9
28
9.8
Introduced the management of new spool change
detection sensors H/T.
18.1
29
9.9
Intermediate version
18.1
30
10.0
Fixed bug in identify procedure for spool change detection
sensors H/T.
Introduced the possibility to Enable/Disable FBUS OVER
Warning message.
Introduced the possibility for TS55 firmware upgrade.
Fixed upgrade malfunctioning in case of FTP interface not
available.
Introduced protection for PFD firmware upgrade
Modified “Tension Drop” programming modality
for spool change detection sensors H/T.
Fixed Offset procedure malfunctioning in case of ACTD
boards connected.
18.4-18.6