Web-up fix communication for single Loop configuration
Disabled ACTD activation for disabled positions (set as
OFF, reference 0x12)
Matrix Touch Diaper 19.0: calibration procedure
optimization; side button check menu
SMDIN/MULTILOOP:
Thread-up button always visible as line is in “STOP” mode,
also when ALARMS or WARNING are displayed; function
modified to allow thread-up for single position; specific
message on DF display.
Added Function for DF and TMS led blink green-red as the
position is in alarm, only for alarms generated by BTSR
local logic (enable-disable available in SMDIN menu)
TMS led is set red when position is disabled
Corrected initialization and factory reset values for local
alarms
Corrected SMDIN labelling for local alarms, with detail of
TMS or DF alarm
Local Alarm thresholds automatic refreshed when setpoint
is updated
System Status Message on SMDIN display coherent with
Matrix Touch display (STOP, RUN, ALARM)
DIAPERFEEDER disabling logic modified (required DF
firmware 3.6.10)
Notes for Communication Protocol:
Modified 0x41 protocol function not to reset Spool Change
Warning (already available 0x42 function)
Introduced Thread-up from PLC (function 0x3B)
Matrix Touch:
Matrix Touch lateral button colours modification
Error Counter modification and added last reset date/time
Display Calibration procedure fix
Modified Creel Structure menu, definition of creel name
and elastic product numbering
Optimization of external Time Sync
BUS Message log info recorded in the non-volatile memory
To Next Page
Loading...