The functions4
20 Operating instructions RC20 room controller • Issue 08/2006
We reserve the right to make any changes due to technical modifications.
4.5 What is a heating program?
A heating program controls the automatic changeover of operating
modes (day and night mode) at fixed times. The heating program
also determines the times for DHW heating and the operation of
the circulation pump.
Before you select a heating program, consider the following:
– At what time in the morning do you want your home to be
warm? Does this time also depend on the day of the week?
– From what time in the evenings do you no longer need
heating? This too may depend on the day of the week.
The RC20 room controller from Buderus offers eight preset
standard programs that can be selected straightaway.
If the room controller has been installed as a remote control unit for
an RC30/RC35 programming unit, heating programs from the
RC30/RC35 can be used in the RC20 ("Own program",
see section 4.7 "Heating program summary", page 22).
USER NOTE
The time taken for your heating system to heat up individual
rooms may vary. This will be subject to the outside temperature,
the building insulation and the drop in room temperature.
To Next Page
Loading...
