ISOMET™ 2000 Accessories and Supplies
Accessories
Part No. Description
11-1191
FLANGES, 1-3/4″ (44 mm) dia., recessed, set of two for use with larger specimens where greater depth of
cut is required.
11-1197 FLANGES, 2.5” (64mm) DIA. set of two for use with larger diameter blades where greater depth of cut is
required.
11-2282
FLANGES, 3″ (76 mm) dia., set of two for use with larger diameter blades where greater depth of cut is
required.
11-2283
FLANGES, 4″ (102mm) dia., set of two for use with larger diameter blades when higher cutting speed and
additional blade support is required.
11-2284
FLANGES, 5″ (127 mm) dia., set of two for use with larger diameter blades where maximum cutting speed
and blade support is required.
11-2481 GONIOMETER, for precision sectioning of samples along specific planes, each axis provides monument in
2″ increments.
11-2482
FASTENER CHUCK, 1-1/8″ - 2-1/8″ (29mm - 54mm) length capacity, for longitudinal sectioning of
fasteners, tubes and solid cylinders.
11-2483
DOUBLE SADDLE CHUCK, 1-3/8″ (35mm) dia. capacity, prevents possible damage to specimen by
holding sectioned portion firmly after cutting is completed.
11-2484
GLASS SLIDE CHUCK, 1-1/8″ W x 1-7/8″ L (29mm x 46 mm) capacity, for thin sectioning of specimens
mounted to a glass slide.
11-2485 IRREGULAR SPECIMEN CHUCK, for irregularly shaped samples.
11-2486 THIN SECTIONS AND WAFER CHUCK, for wafers, single crystals and thin sections.
11-2487
SINGLE SADDLE CHUCK, 1-1/4″ (32 mm) diameter capacity, for bar and tube stock.
11-2488
GLASS SLIDE CHUCK, 2″ W x 3″ L (51 mm x 76 mm) capacity, for thin sectioning of specimens mounted
to a glass slide.
11-2489
MOUNTED SPECIMEN CHUCK, 1-1/2″ (38 mm) diameter capacity for mounted samples.
11-2491
DOVETAIL CHUCK, 1-1/4″ (32 mm) for rigid mounting of solid stock.
11-2492
DOVETAIL CHUCK, 1-1/2″ (38 mm) diameter capacity for rigid mounting of solid bar stock.
11-2493 EXTERNAL RECIRCULATING KIT.
11-2494 BONE CHUCK, for gripping bones and other irregularly shaped specimens.
11-1189
MOUNTED SPECIMEN CHUCK, 1″ (25 mm) or 1-1/4″ (32 mm) diameter capacity for mounted samples.
Supplies
Part No. Description
11-2293-016 ISOCUT
®
PLUS FLUID, pint, combination lubricant/coolant concentrate for use with ISOMET™ 2000
Precision Saw.
11-2490
DRESSING STICK for ISOMET™ 2000, 1″ x 1/2″ x 3″ (25 mm x 13 mm x 76 mm) For Series 20 and 15
Diamond Wafering Blades.
11-2495
DRESSING STICK for ISOMET™ 2000, 1″ x 1/2″ x 3″ (25 mm x 13 mm x 76 mm) For Series 10 and 15
Diamond Wafering Blades.
11-2496 ISOMET™ 2000 Chuck Padding, PSA backed.
32
MA112480-20 03/06/00
To Next Page
Loading...
