Buhler 435 - Lubrication & Maintenance Chart

4-6
435/485/535
Section 4 - Lubrication & Maintenance
Lubrication & Maintenance Chart
Lubrication and Maintenance Chart
Service Interval No. Operation Check Clean Lube Change Adjust Drain
Every 10 hours or daily 1 Front grille •
1 Hydraulic cooler •
1 Transmission cooler •
1 Air conditioner condenser •
1 Intercooler •
1 Radiator •
1 Fuel cooler •
2 Engine coolant level •
3 Engine fan/water pump belt tension •
4 Alternator/AC compressor belt tension •
5 Engine oil level •
6 Fuel filter •
7 Auxiliary fuel filter (optional) •
8 Hydraulic oil level •
9 Transmission oil level (all transmissions) •
10 Brake adjustment • •
11 Lower articulation pin •
12 Front steering cylinder pin, 2 off •
13 Rear steering cylinder pin, 2 off •
14 Upper articulation pin •
15 Front drag link pin, 2 off •
16 Rear drag line pin, 2 off •
17 Rear axle drive shaft steady bearing •
18 Air intake pipe •
Every 50 hours 19 Cab air filter •
20 Differential oil level •
21 Alternator •
22 Tire air pressure •
23 Planetary hub oil •
Every 250 hours 24 Engine oil and filter •
25 Fuel filter •
26 Engine supplemental coolant •
27 Transmission oil filter (first startup (CAT TA22) •
28 Transmission oil change* (CAT TA22) •
29 Transmission breather (CAT TA22) •
30 Air conditioner drain hoses •
31 Air conditioner sight glass •
32 Weight kit hardware (optional) •
33 Wheel hardware •
Every 300 hours 34 Transmission filter (1407 Twindisc) •
Every 500 hours 35 Battery connections •
36 Battery electrolyte level •
37 Starter battery connections •
38 Engine air pre-cleaner •
39 Hydraulic suction screen •
40 Hydraulic filter - standard flow •
41 Hydraulic filter - high flow (optional) •
42 Transmission filter (synchromesh only) •