435/485/535
4-15
Operation 10
Parking Brake Adjustment
The foot and parking brake unit is self-adjusting and
requires no maintenance.
Engaging and disengaging the parking brake lever
(1) several times will activate the self-adjusting
mechanism within the caliper and keep the brake in
proper adjustment. This will ensure a proper set point
for the brake to stop the tractor and hold it on an
incline when parked.
Visually inspect the brake rotors front and rear (2) for
nicks or damage and the brake pads for wear. The
pads (3) must be replaced if they are worn to 1 mm
(1/32
") or less. Consult your Buhler Versatile dealer for
assistance in replacement of the brake rotor or pads.
WARNING: ENSURE THAT THE BRAKES ARE IN
GOOD WORKING ORDER BEFORE OPERATING THE
TRACTOR.
Operation 11
Lubricate the Lower Articulation Pin
Lubricate the grease fitting (4) until grease flows
from around the pin seals. This will purge any dirt
accumulated in the pivot pin area.
Start the unit and articulate from side to side to work
the grease into the joint.
Use Moly base grease (NLGI 1 Lithium, Moly).
1
2
2
3
4
Section 4 - Lubrication & Maintenance
Every 10 Hours or Daily
To Next Page
Loading...