435/485/535
4-51
Section 4 - Lubrication & Maintenance
Indicated by Warning Light
Clean the air cleaner body with a lint-free towel before
installing the element.
Inspect the element seal (1) before installing. Cracks
or chips in the element sealing rubber indicates a new
element must be installed.
Install the air filter back into the canister. Be sure
the seal on the end of the filter fully contacts the air
cleaner body. The wing nut (2) has a small seal (3)
on the inner face, and the seal should be in good
condition before the wing nut is tightened. If the seal
is damaged on the wing nut, replace it. Tighten the
nut securely.
1
2
3
To Next Page
Loading...
