Reprogramming a Single
HomeLink@ Button
To
program a device to HomeLink@ using a HomeLink@
button previously trained, follow these steps:
1.
Press and hold the desired HomeLink@ button.
Do not release the button.
2.
The indicator light will begin to flash after
20
seconds. While still holding the HomeLink@
button, proceed with Step
2
under “Programming
HomeLink@.”
Resetting Defaults
To
reset HomeLink@ to default settings do the following:
1.
Hold down the two outside buttons for about
20
seconds until the indicator light begins to flash.
2.
Continue to hold both buttons until the HomeLink@
indicator light turns
off.
3,
Release both buttons.
For questions or comments, contact HomeLink@ at
1-800-355-3515,
or on the internet at
www.homelink.com.
2-46
To Next Page
Loading...
