Dual Automatic Climate Control
System
With this system you can control the heating, cooling
and ventilation for your vehicle.
Automatic Operation
AUTO
(Automatic):
Press the
AUTO
button for
automatic control of the inside temperature, the air
delivery mode and the fan speed.
1.
Press the AUTO button.
2. Adjust the temperature to
75"
F
(24"
C).
Choosing the coldest or warmest temperature
setting will not cause the system to heat or cool
any faster.
If
you set the system at the warmest
temperature setting, the system will remain
in manual mode at that temperature and it will not
go
into automatic mode.
In cold weather, the system will start at reduced fan
speeds
to
avoid blowing cold air into your vehicle
until warmer air is available. The system will
start out blowing air at the floor but may change
modes automatically as the vehicle warms up
to maintain the chosen temperature setting. The
length
of
time needed for warm up will depend on
the outside temperature and the length of time
that has elapsed since your vehicle was last driven.
3.
Wait for the system to regulate. This may take from
10
to 30 minutes. Then adjust the temperature,
if
necessary.
Do
not cover the solar sensor located in the center of
the instrument panel, near the windshield. For more
information
on
the solar sensor, see "Sensors" later in
this section.
3-26
To Next Page
Loading...
