To
recall your memory positions, your vehicle must be
in PARK (P). Push and release the MEMORY button
corresponding to the desired driving position. The seat
and mirrors will move to the position previously stored for
the identified driver. You will hear one beep.
To
store the exit position for an easy exit, use the
following procedure:
1.
First identify the DRIVER
#
by pressing the
MEMORY button
1
or
2
or by pressing the unlock
button on the transmitter.
2.
Adjust the driver’s seat to the desired exit position.
3.
Press and hold the EXIT button for longer than
three seconds. You will hear two beeps confirming
that the seat exit position has been entered into
memory.
To
set the exit position for a second driver, follow the
previous steps, but start by pressing the unlock
button on the transmitter that displays the other
DRIVER
#
on the DIC. Be sure to use the MEMORY
button which corresponds to the DRIVER
#
identified by
the other transmitter.
To recall the exit position, your vehicle must be in
PARK (P). Push and release the EXIT button and the
seat will move to the exit position previously stored
for the current identified driver. You will hear one beep.
If
an exit position has not been stored for the current
identified driver, the seat will move all the way back.
To
stop recall movement of the seat at any time, press
the driver’s power seat control located on the outboard
side of the front seat.
Mirrors and lumbar positions will not be stored or
recalled for the exit position.
If
you would like your stored driving or exit position
to be recalled when unlocking your vehicle with
the transmitter, see
DlC Vehicle Personalization
on
page
3-5
1.
2-50
To Next Page
Loading...
Need help?
General
