Buick 2003 LeSabre User Manual

Aiming
Your vehicle has a visual optical headlamp aiming system
equipped with horizontal aim indicators. The aim has
been preset at the factory and should need
no further
indicators may not fall exactly
on the “0 (zero) marks on
their scales.
If your vehicle is damaged in an accident, the headlamp
aim may be affected. Aim adjustment to the low beam
may be necessary
if it is difficult to see lane markers
(for horizontal aim), or
if oncoming drivers flash their
high beams at you (for vertical aim).
Qrlil trtrnnnt Thio ir tvl tn ntran thnl Inh ItnI vr hnri7nntql qirn
-U,UuLIII”III.
I,IIU
,u ,,U” ”I-,,
IIIWuyII ywu,
IIVIILVIILU, Ullll
If you believe your headlamps need to be re-aimed,
we recommend that you take your vehicle to your dealer
for service. However,
it is possible for you to re-aim
your headlamps as described in the following procedure.
Notice: To make sure your headlamps are aimed
properly, read all the instructions before beginning.
Failure to
follow these instructions could cause
damage to headlamp parts.
The vehicle should be properly prepared as follows:
The vehicle should be placed so the headlamps are
25 ft.
(7.6 m) from a light colored wall or other flat
surface.
The vehicle must have all four tires on a perfectly
level surface which is level all the way to the wall
or other flat surface.
The vehicle should be placed so it is perpendicular
The vehicle should not have any snow, ice or mud
I he vehicle should be tutly assembled and ail other
work stopped while headlamp aiming
is being done.
0 The vehicle should be normally loaded with a
full tank of fuel and one person or
160 Ibs (75 kg)
on the driver’s seat.
to the wall or other flat surface.
attached to it.
Tires should be properly inflated.
5-51

Buick 2003 LeSabre Specifications

General

Brand	Buick
Model	2003 LeSabre
Category	Automobile
Language	English