Driver Information Center (DIC)
Your vehicle may be equipped with a Driver Information
Center (DIC). The DIC will display information about
how your vehicle is functioning, as well as warning
messages
if
a system problem is detected. This feature
also allows two different drivers
to
store and recall
their own personal choice settings. See “DIC Controls
and Displays” following for more information.
DIC Controls and Displays
When you turn the ignition on, the DIC wiil display
your DRIVER
NUMBER.
You can have your dealer
program your name to appear on this display line.
See your dealer for more information.
The system will then perform a status check and display
any messages
if
a problem is detected.
If
there are
no problems detected, the display will return to the mode
selected by that driver the last time the ignition was
turned off.
If a problem is detected, a diagnostic message will
appear in the display. The following pages will show the
messages you may see on the DIC display.
The message center is continuously updated with the
vehicle’s performance status.
The following buttons
are on the DIC control
panel which is located to
the left of the steering
column:
ODOITRIP
(OdometerITrip):
When this button is
pressed, the display will show the total mileage, and
Trip
1
or Trip
2
miles. Trip
1
and Trip
2
will display the
miles traveled since the last reset. To reset the trip
odometer, press the ODO/TRIP button until the preferred
trip number
(1
or
2)
is shown in the DIC display, then
press the RESET button. The trip odometer will
now accumulate miles until the next reset.
3-47
To Next Page
Loading...
Need help?
General
