Care
of
Safety Belts
Keep belts clean and dry.
Do
nc )le:
I
01
-ye safet! elts.
I.
,ou
-A,
it may severely weaken them. In a crash,
they might not be able to provide adequate
protection. Clean safety belts only with mild
soap and lukewarm water.
1
Weatherstrips
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth at least every six
months. During very cold, damp weather more frequent
application may be required. See
Part
D:
Recommended
Fluids and Lubricants on page
6-23.
Cleaning the Outside
of
Your Vehicle
The paint finish on your vehicle provides beauty,
depth of color,
gloss
retention and durability.
Washing
Your
Vehicle
The best way to preserve your vehicle’s finish is to keep it
clean by washing it often with lukewarm or cold water.
Don’t wash your vehicle in the direct rays of the sun.
Use a car washing soap. Don’t use strong soaps
or chemical detergents. Be sure to rinse the vehicle
well, removing all soap residue completely. You can get
GM-approved cleaning products from your dealer.
See
GM Vehicle Care/Appearance Materials
on
page
5-87.
Don’t use cleaning agents that are petroleum
based, or that contain acid or abrasives. All cleaning
agents should be flushed promptly and not allowed
to dry on the surface, or they could stain. Dry the finish
with a
soft,
clean chamois or an all-cotton towel to
avoid surface scratches and water spotting.
High pressure car washes may cause water
to
enter
your vehicle.
5-a4
To Next Page
Loading...
