Finding
a
Station
BAND:
Press this button to switch between AM, FM1,
FM2. The display will show your selection.
TUNE:
Turn this knob to choose a radio station.
la
SEEK
Di
:
Press the right or the left arrow to go to
the next or to the previous station and stay there.
To scan stations, press and hold one
of the
SEEK
arrows for two seconds until SCAN appears on
the display. The radio
will
go to a station, play for a few
seconds, then go
on
to the next station. Press one of
the
SEEK
arrows again to stop scanning.
To scan preset stations, press and hold one
of
the
SEEK
arrows for more than four seconds until PSCAN
and the preset number appear
on
the display. You
will
hear a double beep. The radio will go to the first
preset station stored on your pushbuttons, play for a few
seconds, then go on to the next preset station. Press
one of the
SEEK
arrows again to stop scanning presets.
The radio will seek and scan only to stations that are in
the selected band and only to those with a strong signal.
Setting
Preset
Stations
The six numbered pushbuttons let you return to your
favorite stations. You can set up to
18
stations (six AM,
six FM1 and six FM2) by performing the following steps:
1.
Turn the radio on.
2.
Press BAND to select AM, FM1 or FM2.
3.
Tune in the desired station.
4.
Press
EQ
to select the
EQ
setting. It will be stored
with the preset station.
5.
Press and hold one of the six numbered
pushbuttons. When you hear the radio produce
one beep, release the pushbutton. Whenever you
press that numbered pushbutton, the station you set
will return.
6.
Repeat the steps for each pushbutton.
3-59
To Next Page
Loading...
