Prepare your vehicle as follows:
0
Park your vehicle on a level place. Keep the
1.
Pull
out
the dipstick and wipe it with a clean rag
2.
Push it back in all the way, wait three seconds and
or paper towel.
then pull
it
back out again.
engine running.
0
With the parking brake applied, place the shift lever
in PARK
(P).
0
With your foot on the brake pedal, move the shift
lever through each gear range, pausing for about
three seconds in each range. Then, position the shift
lever in PARK
(P).
I
Let the engine run at idle for three to five minutes.
3.
Check both sides of the dipstick, and read the
Then, without shutting
off the engine, follow these steps: lower level. The fluid level must be in the
cross-hatched area.
push the dipstick back in all the way.
4.
If the fluid level is in the acceptable range,
5-23
To Next Page
Loading...
