The alarm can be tested by following these steps:
1.
From inside the vehicle,
roll
down the driver’s
window and open the driver’s door.
2.
Activate the system by locking the doors with the
power door lock switch while the door
is
open, or
with the remote keyless entry transmitter.
3.
Get out of the car, close the door and wait for the
4.
Then reach in through the window, unlock the
SECURITY light to go out.
door with the manual door lock and open the
door. This should set
off the alarm.
If
the alarm does not sound when it should, but the
vehicle’s lamps flash, check to see
if
the horn works.
The horn fuse may be blown. To replace the fuse,
see
Fuses and Circuit Breakers
on
page
5-90.
If the alarm does not sound or the vehicle’s lamps
do not flash, the vehicle should be serviced by
an authorized service center.
Your PASS-Key@
Ill
system operates on a radio
frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Pari
15
sf
the FCC Rules.
Operation is subject to the following two conditions:
(1)
this device may not cause harmful interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with
RSS-210
of Industry Canada.
Operation is subject to the following two conditions:
(1)
this device may not cause interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
I
*PC\
thie
rrml
m;nm-*.+
vucl
,I
,,d
b,yulyl
I
IbI
IL.
PASS-Key@
Ill
uses a radio frequency transponder in
the key that matches a decoder in your vehicle.
2-1
9
To Next Page
Loading...
Need help?
General
