PREV
(1):
Press this button to search for the previous
selection on the tape. Your tape must have at least three
seconds of silence between each selection for PREV to
work. The sound will mute while seeking.
NEXT
(2):
Press this button to search for the next
selection on the tape. Your tape must have at least three
seconds of silence between each selection for NEXT to
work. The sound will mute while seeking.
The
SEEK
left and right arrows will also find
the
previous and next selections on the tape.
44
(3):
Press this button to reverse the tape rapidly.
Press
it
again to return to playing speed. The radio
will play while the tape reverses.
..
(4):
Press this button to advance quickly to
another part of the tape. Press the button again to
return to playing speed. The radio will play while the
tape advances.
SIDE
(5):
Press this button to change the side of the
tape that is playing.
00
(6):
Press this button to reduce background noise.
The display will show either
OFF
or
ON
for a few
seconds when you press the button.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks
of
Dolby Laboratories Licensing Corporation.
EJECT
Press this button to remove the tape. The radio
will play. If you leave a cassette tape in the player while
listening to the radio, it may become warm.
CLN:
If this message appears on the display, the
cassette tape player needs to be cleaned.
It
will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold
EJECT
for five seconds to
reset the CLN indicator. The radio will display
---
to
show
the
indicator was reset.
3-17
To Next Page
Loading...
