AM-FM Stereo with Cassette Tape Player
and Automatic Tone Control
Playing
the
Radio
VOLUME:
Press this knob to turn the system on and
off.
To
increase volume, turn the knob clockwise. Turn
it counterclockwise to decrease the volume.
RECALL:
Press this button briefly to recall the station
being played or to display the clock. To change what is
normally shown on the display (station or time), press
this button until you see the display you want, then hold
the button until the display flashes. If you press the
button when the ignition is off, the clock will show for a
few seconds.
Finding a Station
AM-FM:
Press this button to switch between
AM,
FM
1
and
FM2.
The display shows your selection.
TUNE:
Press the up or down arrow to choose
radio stations.
SEEK:
Press the up or down arrow
to
go
to the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press one of the
SEEK
arrows for two seconds
and SCAN will appear on the display. Use SCAN to
listen to stations for a few seconds. The radio will go to
a station, stop for
a
few seconds, then go on to the next
station. Press one of the
SEEK
buttons again to stop
scanning. The sound will mute while scanning.
3-18
To Next Page
Loading...
