Bullet DVR dvr - Video File Name; Ejecting the CF Memory Card; Compatible CF Memory Cards; Status Light

7
operating manual
operating manual Product appearance and specications are subject to change without notice
Ejecting the CF memory card:
1. Wait until the Status LED turns to green.
2. Disconnect the AC Charger and turn the Power Switch to the OFF position.
3. Firmly press the Eject button and grab the CF card adapter by the edges
and pull it out of the unit. If you have problems reaching the card, there are
2 small holes on each side of the adapter, which you can grab with a sharp
object and pull out.
Caution:
Once recording has stopped, it takes a short time to save the buered data to the
memory card. The Power Switch cannot be turned o, and the AC Charger should NOT
be disconnected until the LED status light turns to steady green. Ejecting the CF card
too early could damage the integrity of the video le and ruin your recording session.
Video file name:
Recorded video les are stored on the CF memory card with the prex DVR_ by
default, and can be changed by the user. The maximum number of les on the same
CF card is 1000, starting with DVR_000.avi and is incremental to DVR_999.avi
Compatible Compact Flash memory cards:
Currently, the Bullet DVR unit supports the following brands of CF memory cards:
o Sandisk Ultra & Ultra II
o Sandisk Extreme III & Extreme IV
o Transcend 133x
o A-Data 133x & 266x
o Lexar 80x
There are other brands which might work, but have not yet been tested for
compatibility. The minimum speed rating of the card should be 60x, otherwise your
videos could appear choppy.
Contact your Bullet DVR dealer for more information.
Bullet DVR Status Light:
o Steady Green = Unit is in Stand-by mode, ready for operation.
o Quick-Flashing Red = Unit is recording normally.
o Slow-Flashing Red = Unit is recording, but no video source is detected.
o Flashing Orange = Compact Flash memory card is full.
o Flashing Orange (4 times) = Low battery, recording will stop and unit will enter
sleep mode.
o Steady Orange = Unit is in sleep mode, press & hold the stop button to wake
it up.
Battery Care & Maintenance:
The Bullet DVR unit contains a Lithium-Ion rechargeable battery, which has a lifespan
of around 5 years. The battery comes already supplied with a partial charge, so that
you may use it immediately after you open the package. To re-charge the battery,
simply plug-in the AC Charger and the charging procedure will begin automatically.
The Charging Light on the side of the unit will remain red during this time, and will
turn o once the battery is full.
Charging a very low battery takes approximately 5 to 8 hours. A freshly charged
battery should power up the Bullet DVR for around 90 minutes, and about 60 minutes
when a Bullet Camera is connected to the unit as well.