28
BATTERY AND CHARGER
The battery incorporates a Management System (BMS) that monitors the cell’s status
and optimises charging to provide maximum performance and a longer lifespan.
Fully charge the battery before the first use. During charging, the charger LED light
will be yellow. When the battery is fully charged, the charger LED light will turn green,
meaning that the battery is ready for use.
The battery range may vary considerably depending on conditions such as the slope of
the road and pedalling. [See 3.4]
If during a long trip the level of the battery charge drops to 25% of the total capacity
(2 bars on the dashboard), the battery management system will switch to ECO mode
automatically. The system will be deactivated before a complete battery discharge can
occur.
IF THE SAFETY SEAL IS BROKEN IT WILL
RESULT IN THE AUTOMATIC LOSS OF THE
WARRANTY.
FULLY CHARGE THE BATTERY BEFORE
FIRST USE.
NEVER CUT WIRES OR MODIFY ANY
OF THE POWER COMPONENTS. IT CAN
CAUSE SERIOUS INJURY.
THE BATTERY HAS A SAFETY SEAL WITH
SAFETY WARNINGS. BEING A POWER
ELEMENT, IT CAN ONLY BE HANDLED BY A
BULTACO MOTORS DEALER.
7. Check the electrical system of the vehicle (battery, motor, controller, power
wiring). All wires and elements must be in perfect condition and external
connectors positioned correctly.
8. Check the battery charge level on the dashboard. [See 2.4].
If after reading these instructions you still have questions, contact your Bultaco
Motors Dealer, who will be happy to help.
To Next Page
Loading...
