35
After performing the checks described in paragraph 3.1.1., your Brinco is ready to start
riding.
To start it you must follow the procedure descibed below:
3.3. Starting your Brinco
1. Place the Bultaco card or wristband in the front of the dashboard where the NFC
antenna is (both dashboard and wristband/card must have physical contact) until the
dashboard lights up [See 2.4 ].
2. When you turn the system on your Brinco will perform a test and an intermittent
warning light will flash on the dashboard.
Clarification:
If the power button is ON, the warning light will be illuminated permanently and you
must operate any of the brakes before you set o.
YOU WILL RECEIVE A “MASTER” CARD
WITH YOUR BRINCO WHICH WILL
ALLOW YOU TO CREATE COPIES OF
YOUR CARD / WRISTBAND [SEE 3.3.1]
To Next Page
Loading...
